Celica 2WD L4-2.0L (3S-FE) (1988)
20.
TIGHTEN SCREW OF ENGINE HOOD RELEASE LEVER
(a)
Tighten the two screws.
21.
INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL
(a)
Insert the clips.
(b)
Tighten the screw.
Note:
This screw is gray color.
22.
INSTALL LH FRONT "A" PILLAR GARNISH
Install the garnish same as the RH side.
23.
INSTALL STEERING COLUMN COVER (w/o Tilt Steering)
(a)
Install the column cover and tighten the seven screws.
24.
a) Replace steering wheel, aligning the tape marks on the wheel and the upper steering column cover.
b)
Tighten the nut to 400kg-cm (29 ft.lbs.)
c)
Connect wires at the horn plate and reinstall steering wheel horn pad.
25.
CONNECT BATTERY CABLE TO NEGATIVE TERMINAL
Use the following check list to ensure that:
1)
All switches/systems function correctly after the repair.
2)
The fit of all parts and trim pieces is correct.
Final Inspection
Item
Check For
Switches
(1)
Rear window defogger Light up by switch in ON position
(2)
Hazard Hazard lights operate
(3)
Cruise control main Switch illuminates in ON position
(4)
Power lumbar and side Operation support control (GT-S, Turbo All-Trac)
(5)
Overdrive (A/T only) Indicator light in Combination Meter illuminates with switch in OFF position
(6)
Driving pattern selector Indicator light
(ECT only)
illuminates in