Celica Coupe L4-132 2164cc 2.2L DOHC (5S-FE) (1992)
/Page-329005.png)
19. Remove crankshaft pulley.
(a) Using SST 09213-54015 (09214-00030) and 09330-00021, remove the pulley bolt.
HINT: (When re-using timing belt)
After loosening crankshaft pulley bolt, check that the timing belt match-mark aligns with the end of the No.1 timing belt cover when the crankshaft
pulley groove is aligned with the timing mark "0" of the No.1 timing belt cover. If the matchmark does not align, align as follows:
(When matchmark is out of alignment on clock-wise)
^
Align the matchmark by pulling the timing belt up on the water pump pulley side while turning the crankshaft pulley counterclockwise.
^
After aligning the matchmark, hold the timing belt. And turn the crankshaft pulley clockwise, and align its groove with timing mark "0" of the
No.1 timing belt cover.
