Celica Coupe L4-132 2164cc 2.2L DOHC (5S-FE) (1992)
/Page-1109003.png)
CAMBER
If camber angle is not to specification, adjust by turning the camber adjusting cam. Loosen the shock absorber set nut and turn cam to obtain correct
adjustment. Camber angle changes approximately 20° with each graduation of the adjusting cam. After adjustment, torque cam adjusting bolt to 166 ft.
lbs.
CASTER
Caster angle is not adjustable. If caster angle is not to specification, check suspension components and replace worn or damaged components as required.
Toe-In
If toe-in reading obtained is not as specified, remove boot clip and loosen locknut. Turn the left and right rack ends in equal amounts to adjust. Ensure
the lengths of the left and right tie rods are the same.
