Celica Coupe L4-132 2164cc 2.2L DOHC (5S-FE) (1992)
/Page-1140002.png)
Fig. 6 Exploded View Of Rear Suspension. 1990-93 Celica Less AWD
1.
On coupe models, remove rear speaker board.
2.
On hatchback models, remove rear speaker grill.
3.
On models equipped with ABS, disconnect speed sensor electrical connector from shock absorber.
4.
On all models, disconnect brake hose from wheel cylinder or caliper, then disconnect brake hose from shock absorber.
5.
Working inside vehicle, loosen nut securing suspension support to shock absorber, Figs. 5 and 6. Do not remove nut at this time.
6.
Disconnect stabilizer bar from shock absorber.
7.
Remove bolts securing shock absorber to axle carrier, then disconnect shock absorber from carrier.
8.
Working inside vehicle, remove nuts securing suspension support to vehicle body, then remove shock absorber, Figs. 5 and 6.
9.
Install a bolt and two nuts in shock absorber lower mounting bracket and clamp unit in a suitable vise using lower mounting bracket as clamping
surface.
10.
Using a suitable spring compressor, compress coil spring.
11.
Remove nut securing suspension support to shock absorber, then remove suspension support, coil spring, insulator and spring bumper, Figs. 5 and
6. Shock absorber is filled with colorless, odorless and non-poisonous high pressure gas. Upon removal, handle shock absorber with care.
Do not score or scratch exposed part of piston rod or allow paint or oil to come in contact with it. Do not rotate piston rod and cylinder
assembly with shock absorber fully extended. When discarding shock absorber, drill a small hole in bottom of cylinder to relieve
pressure.
12.
Reverse procedure to install.
