Celica Coupe L4-132 2164cc 2.2L DOHC (5S-FE) (1992)
/Page-866001.png)
Wheel Bearing: Service and Repair
Front
Fig. 5 Exploded View Of Axle Hub & Steering Knuckle.
1.
Raise and support front of vehicle, then remove tire and wheel assembly.
2.
Remove cotter pin and bearing locknut cap.
3.
With brake pedal depressed, remove bearing locknut, Fig. 5.
4.
Remove brake caliper from steering knuckle and suspend out of way.
5.
Remove disc rotor, then ensure bearing play in axial direction does not exceed .002 inch.
6.
On models equipped with ABS, remove speed sensor from steering knuckle.
7.
On all models, remove cotter pin and nut, then, using suitable puller, disconnect tie rod end from steering knuckle.
8.
Remove steering knuckle-to-strut lower bracket attaching nuts and bolts.
9.
Disconnect steering knuckle from lower suspension arm.
10.
Using plastic hammer, tap axle shaft to loosen it while removing steering knuckle and axle hub. Using puller tool No. 09950-20017 or equivalent,
remove hub from axle shaft. Cover driveshaft boot with cloth to prevent damage.
11.
Remove ball joint from steering knuckle.
12.
Remove steering knuckle inner seal.
