Celica Coupe L4-132 2164cc 2.2L DOHC (5S-FE) (1992)
/Page-877006.png)
c. Check the side gear backlash.
Measure the side gear backlash while holding one pinion gear toward the case.
Standard backlash: 0.05 - 0.20 mm (0.0020 - 0.0079 in.)
If the backlash is not within specification, install a thrust washer of different thickness.
d. Using a pin punch and hammer, drive in the straight pin through the case and hole in the pinion shaft.
e. Stake the differential case.
2. INSTALL RING GEAR
a. Clean the contact surface of the differential case and the threads of the ring gear and differential case.
b. Heat the ring gear in boiling water.
c. After the moisture on the ring gear has completely evaporated, quickly install the ring gear to the differential case.
