Celica GT-S L4-1.8L (2ZZ-GE) (2000)
/Page-778001.png)
Transmission Speed Sensor: Service and Repair
ON-VEHICLE REPAIR
1. REMOVE BATTERY
2. REMOVE ECM AND ECM CASE
3. REMOVE ECM BRACKET
4. DISCONNECT INPUT TURBINE SPEED SENSOR CONNECTOR
5. REMOVE INPUT TURBINE SPEED SENSOR
a) Remove the bolt and input turbine speed sensor.
b) Remove the O-ring from the input turbine speed sensor.
6. INSTALL INPUT TURBINE SPEED SENSOR
a) Coat a new O-ring with ATIF and install it to the input turbine speed sensor.
b) Install the input turbine speed sensor with the bolt.
Torque: 11 Nm (115 kgf-cm, 8 ft. lbs.)
7. CONNECT INPUT TURBINE SPEED SENSOR CONNECTOR
8. DISCONNECT COUNTER GEAR SPEED SENSOR CONNECTOR
9. REMOVE COUNTER GEAR SPEED SENSOR
a) Remove the bolt and counter gear speed sensor.
b) Remove the O-ring from the counter gear speed sensor.
