toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Airbag - Inspect, Replacement & Disposal After Collision|Page 4209 > < Airbag - Inspect, Replacement & Disposal After Collision|Page 4207
Page 3
background image

Note 3 - Inspect and if necessary replace the Steering Wheel:
^  If the steering wheel is diagnosed as needing replacement during inspection

Note 4 - Replace the Passenger Airbag assembly:
^  If the passenger airbag has been deployed or dropped
^  If the airbag is diagnosed as needing replacement when troubleshooting or during inspection

Note 5 - Visually inspect and if necessary replace the following items if deformed:
^  Instrument panel and instrument panel reinforcement
^  Glove compartment or glove compartment door

Note 6 - Replace the Front Impact Sensors:
^  If either the driver or passenger airbag has deployed (replace both front impact sensors)
^  If a front airbag sensor is diagnosed as needing replacement when troubleshooting or during inspection

Note 7 - Replace the Airbag Sensor Assembly:
^  If any airbag has been deployed in a collision or the airbag sensor assembly has been dropped or is diagnosed as needing replacement when

troubleshooting

Note 8 - Inspect and if necessary replace the Wire Harness assembly:
^  If any part of the SRS wire harness or any connector is diagnosed as needing replacement when troubleshooting or during inspection

Note 9 - Replace the:
^  Side Impact Airbag if it has been deployed dropped or is diagnosed as needing replacement when troubleshooting or during inspection
^  Seat cover if it has cuts and/or frayed seams or is diagnosed as needing replacement during inspection
^  Seat frame if it is bent or has become damaged

Note 10 - Replace the Side Impact Sensors:
^  If the side airbag assembly has been deployed dropped or is diagnosed as needing replacement when troubleshooting or during inspection

Note 11 - In the event of driver or passenger airbag deployment replace all seatbelt Pretensioners.

DISPOSAL

HINT:
When scrapping vehicle equipped with an SRS or disposing of a steering wheel pad (with airbag), always first deploy the airbag in accordance with the
procedure described below. If any abnormality occurs with the airbag deployment, contact the SERVICE DEPT. of TOYOTA MOTOR SALES, U.S.A.
INC. When disposing of a steering wheel pad with an airbag deployed in a collision, follow the same procedure given in step 1-(d) in "DISPOSAL"

CAUTION:

-  Never dispose of a steering wheel pad which has an undeployed airbag.

-  The airbag produces a sizeable exploding sound when it deploys, so perform the operation out of doors and where it will not create a nuisance to

nearby residents.

-  When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away from electrical

noise. SST 09082-00700

-  When deploying an airbag, perform the operation at least 10m (33ft) away from the steering wheel pad.

-  The steering wheel pad is very hot when the airbag is deployed, so leave it alone for at least 30 minutes after deployment.

Airbag - Inspect, Replacement & Disposal After Collision|Page 4209 > < Airbag - Inspect, Replacement & Disposal After Collision|Page 4207