Celica GT-S L4-1.8L (2ZZ-GE) (2000)
/Page-62002.png)
a. Remove the 2 clamp bolts holding the sensor harness from the body and shock absorber.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
b. Remove the speed sensor installation bolt from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: At the time of installation, please refer to the following item. There are no foreign objects on the sensor or the part of the knuckle
to which the sensor is to be installed. The sensor is installed flat against the knuckle when you tighten the bolt.
INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, CHECK SPEED SENSOR SIGNAL
