Celica GT-S L4-1.8L (2ZZ-GE) (2000)
/Page-1027005.png)
a. Using a screwdriver with vinyl tape wound around its tip, remove the oil seal.
NOTICE: Be careful not to damage the bushing of the front housing.
b. Coat a new oil seal lip with power steering fluid.
c. Using SST, press in the oil seal.
SST 09950-60010 (09951-00280), 09950-70010 (09951-07100)
NOTICE: Make sure that the oil seal is installed facing in the correct direction.
REASSEMBLY
NOTICE: When using a vise, do not overtighten it.
1. COAT PARTS INDICATED BY ARROWS WITH POWER STEERING FLUID
2. INSTALL VANE PUMP SHAFT WITH VANE PUMP PULLEY
3. INSTALL SIDE PLATE
a. Coat 2 new O-rings with power steering fluid, and install them to the side plate.
b. Align the dent of the side plate with the dent of the front housing, and install the side plate.
NOTICE: Make sure that the side plate is installed facing in the correct direction.
