Celica GT-S L4-1.8L (2ZZ-GE) (2000)
NOTICE: Be careful not to damage or twist the boot.
c. After winding and tightening the wire around the circumference of the boot twice, twist it several times, and install it.
d. As shown in the illustration, bend the wire to the circular direction to prevent damage to the boot.
e. Employ the same manner described above to the other side.
13. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks; are aligned.
b. After adjusting toe-in, torque the nut.
Torque: 74 Nm (750 kgf.cm, 54 ft. lbs.)
c. Employ the same manner described above to the other side.
14. INSTALL 2 TURN PRESSURE TUBES
Using SST, install the 2 turn pressure tubes.
SST 09633-00020
Torque: 20 Nm (200 kgf.cm, 14 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.