Celica GT L4-1.8L (1ZZ-FE) (2001)
Transmission Temperature Sensor/Switch: Service and Repair
ON-VEHICLE REPAIR
1. DISCONNECT SOLENOID CONNECTOR
2. REMOVE LH ENGINE UNDER COVER
3. REMOVE DRAIN PLUG AND DRAIN ATF
4. REMOVE OIL PAN AND GASKET
NOTICE: Some fluid will remain in the oil pan.
Remove the 19 bolts, and carefully remove the oil pan assembly. Discard the gasket.
5. REMOVE OIL STRAINER
a. Remove the 3 bolts and oil strainer.
b. Remove the O-ring.
6. DISCONNECT 5 SHIFT SOLENOID VALVE CONNECTORS
7. REMOVE ATF TEMPERATURE SENSOR
a. Remove the bolt and lock plate, and remove the ATF temperature sensor.
b. Remove the O-ring from the ATF temperature sensor.
8. INSTALL ATF TEMPERATURE SENSOR
a. Coat a new O-ring with ATF and it to the direct clutch speed sensor.