Celica GT L4-1.8L (1ZZ-FE) (2001)
a. Insert a piano wire between body and glass and let it pass through.
b. Tie both wire ends to wooden blocks or similar objects.
c. w/ Front window defogger:
Disconnect the connector.
NOTE: Be careful not to damage the wire harness.
d. Cut the adhesive by pulling the piano wire around it.
NOTE: When separating the glass, take care not to damage the paint and exterior ornaments. To prevent the safety pad from being scratched
when removing the windshield, place a plastic sheet between the piano wire and safety pad.
HINT: Apply protective tape to the outer surface to keep the surface from being scratched.
e. Remove the glass.
NOTE: Leave the adhesive on the body as much as possible when cutting off the glass.
INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
a. Using a knife, cut away any rough areas on the body.
HINT: Leave the adhesive on the body as much as possible.
b. Clean the cut surface of the adhesive with a shop rag saturated in cleaner.
HINT: Even if all the adhesive has been removed, clean the body.