Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
Torque: 19 Nm (14 ft. lbs.)
(g) Apply MP grease to a new oil seal lip.
(h) Using SST Crankshaft Front Oil Seal Replacer # 09223 - 46011 or equivalent and a hammer, tap in the oil seal.
B. Install exhaust camshaft.
(a)
Set the knock pin of the intake camshaft at 10 - 45° BTDC of camshaft angle.
NOTE: The above angle allows the No. 2 and No. 4 cylinder cam lobes of the exhaust camshaft to push their valve lifters evenly.
(b) Apply MP grease to the thrust portion of the camshaft.
(c)
Engage the exhaust camshaft gear to the intake camshaft gear by matching the timing marks on each gear.
(d) Roll down the exhaust camshaft onto the bearing journals while engaging gears with each other.
CAUTION: There are also assembly reference marks on each gear as shown in the illustration. Do not use these marks.
(e)
Turn the intake camshaft clockwise or counterclockwise a little until the exhaust camshaft sits in the bearing journals evenly without
rocking the camshaft on the bearing journals.
CAUTION: It is very important to replace the camshaft in the bearing journals evenly while tightening bearing caps in the subsequent
steps.
