Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
Connecting Rod: Service and Repair
Disassembly
DISCONNECT CONNECTING ROD FROM PISTON
1. Using a small screwdriver, pry out the 2 snap rings.
2. Gradually heat the piston to 80° - 90° C (176° - 194° F).
3. Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.
NOTE:
^
The piston and pin are a matched set.
^
Arrange the pistons, pins, rings, connecting rods and bearings in the correct order.
