Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
(g) Lay a strip of Plastigage across the crank pin.
(h) Install the connecting rod cap with the 2 nuts.
Torque:
1st: 25 Nm (18 ft. lbs.)
2nd: Turn additional 90°.
CAUTION: Do not turn the crankshaft.
(i)
Remove the 2 nuts and connecting rod cap.
(See procedure (b) and (c) above).
(j)
Measure the Plastigage at its widest point.
Standard oil clearance:
STD: 0.024 - 0.055 mm (0.0009 - 0.0022 inch)
U/S 0.25: 0.023 - 0.069 mm (0.0009 - 0.0027 inch)
Maximum oil clearance: 0.08 mm (0.0031 inch)
If the oil clearance is greater than maximum, replace the bearings. If necessary, grind or replace the crankshaft.
NOTE: If using a standard bearing, replace it with one having the same number marked on the connecting rod cap. There are 3 sizes of
standard bearings, marked "1", "2" and "3" accordingly.
Standard sized bearing center wall thickness:
