Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
4. Adjust differential case side bearing preload.
a. Install the differential to the transaxle case.
b. Install the transmission case.
c. Install and torque the case bolts.
Torque: 29 N.m (22 ft. lbs.).
d. Install the shim into the transmission case.
e. Install the bearing retainer without an O-ring.
f.
Install and torque the 6 bolts.
Torque: 18 N.m (13 ft. lbs.).
g. Using SST and a torque wrench, measure the preload.
SST 09564-32011
-
Preload (at starting): 0.8-1.6 N.m (6.9-13.9 inch lbs.).
If the preload is not within the specification, remove the transmission case side bearing retainer. Select another shim.
HINT: The preload will change about 0.3-0.4 N.m (2.6-3.5 inch lbs.). with each 0.05 mm (0.0019 inch) change in shim thickness.
h. Remove the 6 bolts.
i.
Remove the bearing retainer and shim.
j.
Remove the 17 bolts.
k. Remove the transmission case.