Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
-
Using a dial indicator, measure the radial clearance between the gear and shaft.
Standard clearance: 0.009-0.053 mm (0.0004-0.0021 inch) .
Maximum clearance: 0.070 mm (0.0028 inch).
If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.
3. Remove snap ring.
-
Using 2 screwdrivers and a hammer, tap out the snap ring.
4. Remove rear bearing, 4th gear, needle roller bearing, spacer and synchronizer ring from input shaft.
a. Using SST and a press, remove the 4th gear and rear bearing.
SST 09950-00020
b. Remove the needle roller bearings, spacer and synchronizer ring.
5. Remove snap ring.
-
Using a snap ring expander, remove the snap ring.
6. Remove no. 2 hub sleeve assembly, 3rd gear synchronizer ring and needle roller bearing.
-
Using SST and a press, remove the No.2 hub sleeve, 3rd gear, synchronizer ring and needle roller bearings.
SST 09950-00020
NOTICE: Be careful not to mistake the 3rd gear synchronizer ring for the 4th gear synchronizer ring.
7. Remove No.2 hub sleeve, shifting key and spring from No.2 clutch hub.
-
Using a screwdriver, remove the 3 shifting keys and 2 springs from the No.2 clutch hub.
