Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
2. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the connector.
NOTE: Remove the connectors with the sensor assembly installed.
b. Using a torx wrench remove the 4 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool).
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 4 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 21 Nm (210 kgf.cm, 15 ft.lbf)
b. Connect the connectors.
NOTE:
-
Installation of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
-
After installing, shake the sensor assembly to check that there is no looseness.
2. INSTALL REMOVED PARTS