Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
8. Remove the starter housing and clutch assembly from the brass bar.
9. Using a plastic-faced hammer, tap the clutch shaft and install the stop collar onto the snap ring.
15. INSPECT REAR BEARINGS
Turn each bearing by hand while applying inward force.
If resistance is felt or the bearing sticks, replace the bearing.
16. IF NECESSARY, REPLACE REAR BEARING
a. Using SST, remove the bearing.
SST 09286-46011
b. Using a press, press in a new front bearing.
17. INSPECT FRONT BEARING
Turn each bearing by hand while applying inward force.
If resistance is felt or the bearing sticks, replace the bearing.
18. IF NECESSARY, REPLACE FRONT BEARING
a. Using SST remove the bearing.