Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
_mfi/Page-1283001.png)
Alignment: Service and Repair
Rear
INSPECTION
1. MEASURE VEHICLE HEIGHT
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER
Camber is not adjustable, if measurement is not within specification, inspect and replace the suspension parts as necessary.
Measuring Point Reference
4. INSPECT TOE-IN
If the toe-in is not within the specification, adjust it at the No.2 lower suspension arm.
5. ADJUST TOE-IN
a. Measure the length of the left and right No.2 lower suspension arms.
No.2 lower suspension arm length difference: 1 mm (0.04 inch) or less
If the left-right difference is greater than the specification, adjust the length.
