Celica GT Liftback L4-2164cc 2.2L DOHC MFI (1998)
8. Remove master cylinder.
Remove the 2 mounting nuts and pull out the 2 or 3-way union, bracket, master cylinder and gasket.
Torque: 13 Nm (9 ft. lbs.)
INSTALLATION
Instal in the reverse order of removal.
1. Before installation, adjust length of brake booster push rod.
a. Install a new gasket on the master cylinder.
b. Set the SST 09737-00010 on the gasket, and lower the pin until its tip slightly touches the piston.
c. Turn the (SST) upside down, and set it on the booster.
d. Measure the clearance between the booster push rod and pin head (SST).
Clearance: 0 mm (0 inch)
e. Adjust the booster push rod length until the push rod lightly touches the pin head.
2. After installation, fill brake reservoir with brake fluid and bleed brake system.
3. Check for leaks, check and adjust brake pedal.
