Celica GT Liftback L4-2164cc 2.2L DOHC MFI (1998)
Impact Sensor: Service and Repair
REMOVAL
NOTICE:
-
If the wiring connector of the SRS is disconnected with the ignition switch at ON or ACC position, DTCs will be recorded.
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the sensor involved in a collision when the SRS has deployed.
-
Never repair a sensor in order to reuse it.
1. REMOVE THESE PARTS
a. Engine under cover.
b. Front fender liner RH and LH
c. Front bumper cover
2. REMOVE FRONT AIRBAG SENSOR (RH AND LH)
a. Disconnect the connector.
NOTICE: Disconnect the connector with sensor assembly installed.
b. Remove the bolt and nut from condenser.
c. Tilt back the radiator and condenser.
NOTICE: Ensure that strong force is not applied to the refrigerant line which is connected to the condenser and radiator hose.
d. Using a torx wrench remove the 2 screws and front airbag sensor.
Torx wrench: T40 (Part No. 09042-00020 or locally manufactured tool).
INSTALLATION
1. INSTALL FRONT AIRBAG SENSOR
a. Tilt back the radiator and condenser
NOTICE: Ensure that strong force is not applied to the refrigerant line which is connected to the condenser and radiator hose.
b. Install the front airbag sensor with the arrow on the sensor facing toward the front of the vehicle.
