Celica GT Liftback L4-2164cc 2.2L DOHC MFI (1998)
a. Unsolder and remove the brush and spring.
b. Run the wire of a new brush through the hole in the brush holder, and insert the spring and brush into the brush holder.
c. Solder the brush wire to the brush holder at specified exposed length.
Exposed length: 10.5 mm (0.413 in.)
d. Check that the brush moves smoothly in the brush holden
e. Cut off the excess wire.
f.
Apply insulation paint to the soldered area.
8. INSPECT POSITIVE RECTIFIER
a. Using an ohmmeter, connect one tester probe to the positive (+) terminal and the other to each rectifier terminal
b. Reverse the polarity of the tester probes and repeat step (a).
c. Check that one shows continuity and the other shows no continuity.
If continuity is not as specified, replace the rectifier holder.
9. INSPECT NEGATIVE RECTIFIER
a. Using an ohmmeter, connect one tester probe to each negative (-) terminal and the other to each rectifier terminal.
b. Reverse the polarity of the tester probes and repeat step (a).
c. Check that one shows continuity and the other shows no continuity
If continuity is not as specified, replace the rectifier holder
