Celica GT Liftback L4-2164cc 2.2L DOHC MFI (1998)
NOTICE: Be careful not to damage or twist the boot.
c. Tighten the clamp, as shown in the illustration.
d. Install the clip.
20. Install the right and left hand tie rod ends and lock nuts and do these procedures.
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, tighten the nut.
Torque: 56 Nm (41 ft. lbs.).
21. Install the two turn pressure tubes.
a. Install the two union seats to the rack housing.
b. Using the 09633 - 00020 SST, install the tube.
Torque: 19 Nm (14 ft. lbs.).
HINT: Use a torque wrench with a fulcrum length of 250 mm (9.84 inch). This torque value is effective in case that SST is parallel to a torque
wrench.
