Celica GT Ltd Ed Convertible L4-2164cc 2.2L DOHC MFI (1997)
c. Using a feeler gauge, measure the clearance between the synchronizer ring back and gear spline end.
Minimum clearance: 0.7 mm (0.028 inch).
If the clearance is less than the minimum, replace the synchronizer ring.
3. Inspect shift fork and hub sleeve clearance.
-
Using a feeler gauge, measure the clearance between the hub sleeve and shift fork.
Maximum clearance: 1.0 mm (0.039 inch).
If the clearance exceeds the maximum, replace the shift fork or hub sleeve.
4. Inspect output shaft.
a. Using a micrometer, measure the outer diameter of the output shaft journal surface.
Minimum outer diameter:
Part A: 31.970 mm (1.2587 inch).
Part B: 37.970 mm (1.4949 inch).
Part C: 31.990 mm (1.2594 inch).
If the outer diameter is less than the minimum, replace the output shaft.
b. Using a dial indicator, check the shaft runout.
Maximum runout: 0.05 mm (0.0020 inch).
If the runout exceeds the maximum, replace the output shaft.
