Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
Fig. 1 Exploded View Of Rear Disc Brake Caliper Assembly.
1.
Remove caliper from torque plate, then remove sliding bushing and boot, Fig. 1.
2.
Remove main pin boot using a suitable chisel.
3.
Remove piston using compressed air. When using air pressure to remove caliper piston, place a shop towel over piston to prevent it from
flying out.
4.
Remove caliper boot, set ring and piston seal from caliper.
5.
Reverse procedure to install, noting the following:
a. Apply suitable grease to the main pin boot, sliding pin and boot, piston seal and piston and dust boot.
b. Install main pin boot using a press and suitable socket.
c. Ensure dust boot does not fold under during installation.