Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
/Page-1176001.png)
Parking Brake Shoe: Service and Repair
Fig. 3 Exploded View Of Rear Disc Brake Parking Brake Assembly. 93-94 Supra, Celica
Fig. 4 Exploded View
1.
Raise and support rear of vehicle, then remove tire and wheel assembly.
2.
Remove rear caliper, refer to CALIPER SERVICE.
3.
Remove rotor disc.
4.
Remove shoe return springs, Figs. 3 and 4.
5.
Using strut remover 09717-20010, or equivalent, remove shoe strut and spring.
6.
Slide front shoe from under shoe hold-down spring, then remove shoe adjusting screw, tension spring and remove shoe.
7.
Slide rear from shoe hold-down spring, then disconnect parking brake cable from shoe lever.
8.
Apply non-melting grease on brake backing plate shoe flats, then on shoe sliding surface.
9.
Lubricate adjusting screw with non-melting lubricant.
10.
Connect parking brake lever to cable.
11.
Slide rear shoe into position under shoe hold-down spring, then install tension spring.
12.
Install adjusting screw on rear shoe and partially install on front shoe.
13.
Slide front shoe into position under shoe hold-down spring. Ensure adjusting screw and tension spring are positioned properly.
14.
Install front shoe return spring, then rear return spring.
15.
Lightly sand brake drum inner surface, then align the service hole on disc with groove on axle shaft and install disc.
16.
Install caliper, then adjust parking brake.
