Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
High-Tension Cord: Testing and Inspection
HIGH-TENSION CORDS INSPECTION
1. REMOVE HIGH-TENSION CORDS.
To Remove The High Tension Cords, Pull On The Boot, Not The Cord
-
Disconnect the high - tension cords at the rubber boot.
DO NOT pull on the cords.
NOTE: Pulling on or bending the cords may damage the conductor inside.
2. INSPECT HIGH-TENSION CORD RESISTANCE.
Testing A High Tension Ignition Cable
-
Using an ohmmeter, measure the resistance.
Maximum resistance: 25 k Ohms per cord
-
If the resistance is greater than maximum. replace the high -tension cord.
3. REINSTALL HIGH-TENSION CORDS.