Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
Timing Belt: Service and Repair
Timing Belt Installation
1. INSTALL CAMSHAFT TIMING PULLEY
HINT: Align the camshaft knock pin with the knock pin groove of the pulley, and slide the timing pulley on the camshaft.
Torque: 59 Nm (600 kgf-cm, 43 ft-lb)
2. INSTALL CRANKSHAFT TIMING PULLEY
(a) Align the pulley set key with the key groove of the pulley.
(b) Slide the timing pulley on the crankshaft, facing the flange side inward.
3. TEMPORARILY INSTALL IDLER PULLEY AND TENSION SPRING
(a) Install the idler pulley with the bolt. Do not tighten the bolt yet.
(b) Install the tension spring.
(c) Push the pulley toward the left as far as it will go and tighten the bolt.
4. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the hexagonal wrench head portion of the camshaft, and align the hole of the camshaft timing pulley with the timing mark of the bearing
cap.
(b) Using the crankshaft pulley bolt, turn the crankshaft and align the timing marks of the crankshaft timing pulley and oil pump body.
5. INSTALL TIMING BELT
NOTICE: The engine should be cold.