Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
/Page-925005.png)
Secondary Locking Device
b. Push the secondary locking device or terminal retainer in to the full lock position.
5. Connect Connector
Continuity and Resistance Check
Continuity And Resistance Check
a. Disconnect the battery terminal or wire so there is no voltage between the check points.
b. Contact the two leads of an ohmmeter to each of the check points.
Continuity And Resistance Check
-
If the circuit has diodes, reverse the two leads and check again.
-
When contacting the negative lead to the diode positive side and the positive lead to the negative side, there should be continuity.
-
When contacting the two leads in reverse, there should be no continuity.
Continuity And Resistance Check
c. Use a Volt/Ohm meter with high impedance (10 KOhms/Volt minimum) for troubleshooting of the electrical circuit.
Finding A Short Circuit
a. Remove the blown fuse and disconnect all loads of the fuse.
B. Connect a test light in place of the fuse.
c. Establish conditions in which the test light comes ON.
