Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
Transmission Position Switch/Sensor: Service and Repair
PARK/NEUTRAL POSITION SWITCH REPLACEMENT
1. REMOVE NO.2 ENGINE UNDER COVER
2. DISCONNECT SHIFT CABLE FROM MANUAL SHIFT LEVER
3. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
4. REMOVE PARK/NEUTRAL POSITION SWITCH
-
Remove the nut and manual shift lever.
-
Pry off the lock plate and remove the manual valve shaft nut.
-
Remove the 2 bolts and pull out the park/neutral position switch.
5. INSTALL PARK/NEUTRAL POSITION SWITCH
-
Install the park/neutral position switch to the manual valve shaft.
-
Install a new lock plate and tighten the nut.
Torque: 12 Nm (9 ft.lb)
-
Using a screwdriver, stake the nut with lock plate.