Celica Liftback L4-122 1998cc 2.0L DOHC Turbo (3S-GTE) (1992)
/Page-747002.png)
Fig. 8 Valve Body Bolt Identification.
5.
Position valve body in installation position, then insert and finger tighten attaching bolts. Tighten to specifications. Attaching bolt lengths (mm)
are indicated in, Figs. 5 through 8.
6.
On models except A131L, connect solenoid connector.
7.
On A131L models, align manual valve with pin on manual valve lever, then install manual valve body.
8.
Insert and finger tighten attaching bolts, then tighten to specifications.
9.
On all models, install detent spring, then insert and finger tighten attaching bolt. Tighten attaching bolts to specifications.
10.
Ensure manual lever is in contact with center of roller at tip of detent spring, then install oil tubes.
11.
On A240E, A241E, A240L, A241L, A241H, A243L and A244E models, install and torque tube clamp attaching bolt to specifications.
12.
On A131L models, install apply tube bracket, torque to specifications.
13.
On all models, install oil strainer.
14.
Insert magnet into pan, then install oil pan with new gasket.
15.
Insert oil pan attaching bolts, then tighten to specifications.
16.
Install drain plug with new gasket, then tighten to specifications.
17.
Install engine undercover.
18.
Fill transaxle to specifications, then ensure proper fluid level.
