Celica Liftback L4-122 1998cc 2.0L DOHC Turbo (3S-GTE) (1992)
/Page-755008.png)
Fig. 19 Driveshaft Assembly. 1990-93 Celica w/5S-FE Engine
Before disassembling driveshaft, ensure there is no play in the inboard or outboard joints and that the inboard joint slides smoothly in the
thrust direction.
1.
Remove boot clamps, Figs. 18 and 19.
2.
On RH driveshaft except models with 5S-FE engine, remove snap ring from inboard joint shaft
3.
On all models, remove inboard joint boot clamps.
4.
Place matchmarks on inboard joint or center driveshaft. Do not use sharp tool to place matchmarks on inboard joint. Remove inboard joint
tulip or center driveshaft from driveshaft.
5.
Remove outer snap ring, then slide inner snap ring down shaft.
6.
Place matchmarks on driveshaft and tripod, then using brass bar and hammer, remove tripod joint from driveshaft.
7.
Remove snap ring and slide out inboard joint boot.
8.
On RH driveshaft on models with 4A-FE engine, remove damper clamp, then slide out damper.
9.
On all models, remove the two outboard joint boot clamps, then slide out boot from outboard joint.
10.
Except on RH driveshaft on models with 5S-FE engine, using bearing remover tool No. 09950-00020 or equivalent and a press, press out the
dust cover from the inboard joint tulip.
11.
On RH driveshaft with 5S-FE engine, disassemble center driveshaft as follows:
a. Using a suitable press, press out dust cover from center driveshaft.
b. Using screwdriver, remove snap ring, then using suitable press, press out bearing case.
c. Using bearing remover tool No. 09950-00020 or equivalent and a press, press out dust cover, then remove snap ring.
d. Using a press, press out center bearing, then remove snap ring.
e. Using punch and hammer, tap out straight pin.
ASSEMBLY
1.
On RH driveshaft on models with 5S-FE engine, assemble center driveshaft as follows:
a. Using suitable punch and hammer, install straight pin into bearing case using drive pinion front bearing cup replacer tool No. 09608-0060 or
equivalent and a press, press the new bearing into the bearing case, then install snap ring.
b. Using lateral rod bushing removing base tool No. 09710-03140 or equivalent and a press, install bearing case assembly to center driveshaft.
c. Install snap ring, then using differential drive pinion rear bearing replacer tool No. 09506-3510 or equivalent and a press, press a new dust
cover into bearing assembly. The clearance between the dust cover and bearing should be .004-.08 of an inch.
