Celica ST Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1998)
Air Door Actuator / Motor: Testing and Inspection
Air Inlet Servomotor
1. REMOVE INSTRUMENT PANEL
2. REMOVE AIR INLET SERVOMOTOR
a. Disconnect the connector
b. Remove the 2 screws and the servomotor.
3. INSPECT AIR INLET SERVOMOTOR
Inspect servomotor operation
1. Connect the positive (+) lead from the battery to terminal 1 the negative (-) lead to terminal 3, check that the arm rotates to the "FRESH" side
smoothly
2. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, check that the arm rotates to the "RECIRC"
side smoothly,
If operation is not as specified, replace the servomotor.
4. INSTALL AIR INLET SERVOMOTOR
a. Install the servomotor and 2 screws.
b. Connect the connector.
5. INSTALL INSTRUMENT PANEL