Celica ST Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1998)
_mfi/Page-878001.png)
Knock Sensor: Testing and Inspection
INSPECTION
1. REMOVE KNOCK SENSOR 1
(a) Disconnect the knock sensor connector.
(b) Using SST, remove the knock sensor. SST 09816-30010
2. INSPECT KNOCK SENSOR 1
Using an ohmmeter, check that there is no continuity between the terminal and body.
If there is continuity, replace the sensor.
3. REINSTALL KNOCK SENSOR 1
(a) Using SST, instal the knock sensor. SST 09816-30010
Torque: 44 N.m (450 kgf.cm, 33 ft.lbf)
(b) Connect the knock sensor connector.
