Celica ST Ltd Ed Liftback L4-1762cc 1.8L DOHC MFI (1997)
(e) Connect SST (hose) to the fuel inlet of the pressure regulator with SST (union) and the 2 bolts. SST 09268-41045 (09268-41090)
Torque: 9.3 N.m (95 kgf.cm, 82 in.lbf)
(f) Connect the fuel return hose to the fuel outlet of the pressure regulator.
(g) Install the grommet and a O-ring to the injector.
(h) Connect SST (union and hose) to the injector, and hold the injector and union with SST (clamp). SST 09268-41045
(i) Put the injector into the graduated cylinder.
HINT: Install a suitable vinyl hose onto the injector to prevent gasoline from splashing out.
(j) Connect the TOYOTA hand-held tester to the DLC3.
(k) Turn the ignition switch ON and TOYOTA hand-held tester main switch ON.
NOTICE: Do not start the engine.
(l) Select the active test mode on the TOYOTA hand-held tester.
(m)Please refer to the TOYOTA hand-held tester operator's manual for further details.
(n) If you have no TOYOTA hand-held tester, connect the positive (+) and negative (-) leads from the battery to the fuel pump connector.
(o) Reconnect the negative (-) terminal cable to the a battery.
(p) Turn the ignition switch ON.
NOTICE: Do not start the engine.
(q) Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector
2 or 3 times. SST 09842-30070
Volume: 39 - 49 cu.cm (2.3 - 3.0 cu. in.) per 15 sec.
Difference between each injector:
5 cu.cm(0.3 cu in.) or less
If the injection volume is not as specified, replace the injector.
