Celica ST Ltd Ed Liftback L4-1762cc 1.8L DOHC MFI (1997)
the camber adjusting bolt.
i.
Do the above mention steps again. Between the steps (b) and (c), exchange one or two selected bolts, when exchanging two bolts, exchange
one bolt for each time.
7. Adjust the toe-in after doing these procedures.
a. Remove the boot clamps.
b. Loosen the tie rod end lock nuts.
c. Turn the left. and right rack ends an equal amount to adjust the toe-in.
NOTE:
^
Try to adjust the toe-in to the center value.
^
Make sure that the length of the left and right tie rod ends length is the same. The rack end length difference should be 1.5 mm (0.059
inch) or less.
d. Tighten the tie rod end lock nuts to 56 Nm (41 ft. lbs.).
e. Place the boot on the seat and install the clamp.Make sure that the boots are not twisted.
8. Turn the steering wheel fully, and measure the turning angle, the measurements should be as follows.
Inside Wheel: 36°54' ± 2° (36.90° ± 2°).
