Corolla L4-1.8L (1ZZ-FE) (2004)
5. REMOVE BRAKE ACTUATOR ASSY
a. Remove the 3 nuts and brake actuator from bracket.
6. INSTALL BRAKE ACTUATOR ASSY
a. Install the brake actuator with the 3 nuts to the bracket.
Torque: 4.7 Nm (48 kgf-cm, 42 inch lbs.)
7. INSTALL BRAKE ACTUATOR WITH BRACKET
a. Install the brake actuator with bracket with the nut and 2 bolts.
Torque: 19 Nm (194 kgf-cm, 14 ft. lbs.)
b. Using SST, connect the 6 brake tubes to the correct position of brake actuator, as shown in the illustration.
SST 09023-00100
Torque: 15.2 Nm (155 kgf-cm, 11 ft. lbs.)
c. Connect the brake actuator connector.
8. INSTALL FRONT FENDER LINER RH
9. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. FILL RESERVOIR WITH BRAKE FLUID
11. BLEED MASTER CYLINDER
SST 09023-00100
12. BLEED BRAKE LINE
13. CHECK FLUID LEVEL IN RESERVOIR
14. CHECK BRAKE FLUID LEAKAGE
15. CHECK BRAKE ACTUATOR WITH HAND-HELD TESTER