Corolla L4-1.8L (2ZR-FE) (2009)
(e) Reapply a small amount of engine oil to the O-ring of the oil filter cap assembly. Align the cutout in the oil filter cap threads 90° to the grooves
in the oil filter bracket and temporarily tighten the cap.
NOTE: Make sure that the O-ring does not get caught between the parts.
(f) Using SST, tighten the oil filter cap assembly.
Torque: 25 Nm (255 kgf-cm, 18 ft-lbf)
SST: 09228-06501
NOTICE:
-
After tightening the oil filter cap assembly, check for gaps between the installation surfaces.
-
Do not remove the oil filter bracket clip when installing the oil filter cap assembly.
-
Do not cross thread the oil filter cap assembly.
4. ADD ENGINE OIL
(a) Add fresh engine oil and install the oil filler cap.
Engine Oil
Capacity
5. INSPECT FOR OIL LEAK