Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-742001.png)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Brake Actuator Assembly
BRAKE ACTUATOR ASSEMBLY
REPLACEMENT
1. DRAIN BRAKE FLUID
NOTICE: Wash brake fluid off immediately if it adheres to any painted surface.
2. REMOVE FRONT WHEEL RH
3. REMOVE FRONT FENDER LINER RH
4. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
5. REMOVE FRONT BUMPER COVER
6. REMOVE LH HEADLAMP ASSEMBLY
7. REMOVE WINDSHIELD WASHER JAR ASSEMBLY
8. REMOVE BRAKE ACTUATOR WITH BRACKET
a. Disconnect the actuator connector.
b. Using SST, disconnect the 6 brake tubes from the actuator with bracket.
SST 09023-00101
c. Use tags or make a memo to identify the places to reconnect.
d. Remove the 2 bolts, nut and the actuator with bracket.
NOTICE: Be careful not to damage the brake tubes and wire harness.
