Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-328003.png)
B.
Remove the wire harness protector.
a.
Unfasten the 3 clips, then remove the wire harness protector.
b.
Disconnect the pressure sensor connector.
C.
Disconnect the suction hose sub-assembly.
a.
Remove the 2 nuts installing the suction hose sub-assembly.
b.
Disconnect the suction hose sub-assembly.
D.
Remove the drive belt.
a.
Turn the drive belt tensioner clockwise to relieve tension on the belt, and then remove the belt.
b.
Carefully return the tensioner to the unloaded position.
NOTE:
^
When retracting the tensioner, turn it clockwise SLOWLY in 3 seconds or more. Do NOT apply force rapidly.
^
After the tensioner is retracted all the way, do NOT apply more force than is necessary.
4.
Remove and replace the belt tensioner assembly.
