Corolla L4-1.8L (2ZZ-GE) (2005)
b. Using a wooden block and plastic-faced hammer, tap a new gasket in until it is flush with the exhaust manifold.
NOTICE:
^
Make sure that the gasket is the installed in the right direction.
^
Do not reuse the removed gasket.
^
Never push the gasket into the exhaust manifold by installing the exhaust pipe front onto the exhaust manifold.
c. Install the exhaust pipe front onto the exhaust pipe supports No.4.
d. Tighten the 2 compression springs and 2 bolts.
Torque: 43 Nm (440 kgf-cm, 32 ft. lbs.)
12. INSTALL FLOOR PANEL BRACE FRONT
a. Install the floor panel brace front with 2 nuts.
Torque: 30 Nm (302 kgf-cm, 22 ft. lbs.)