Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-261003.png)
Drum brake type: 8.3 Nm (85 kgf-cm, 74 inch lbs.)
Disc brake type: 11 Nm (110 kgf-cm, 8 ft. lbs.)
(6) Repeat the above procedures for each wheel to bleed the air out of the brake line.
e. Bleed the air out of the suction line when "Step 2: Inhalation" appears on the hand-held tester display.
NOTICE:
^
Bleed the air by following the steps displayed on the hand-held tester.
^
Make sure that the brake fluid in the master cylinder reservoir tank does not become empty.
(1) Connect the vinyl tube to the bleeder plug at the right front wheel or the right rear wheel and loosen the bleeder plug.
(2) Operate the brake actuator assembly to bleed the air using the hand-held tester.
NOTICE: At this time, be sure to release the brake pedal.
HINT: This operation stops automatically after 4 seconds.
(3) Check if the operation has stopped by referring to the hand-held tester display.
(4) Repeat (2) and (3) until all air in the fluid is completely bled out.
(5) Tighten the bleeder plug.
Torque:
Front brake: 8.3 Nm (85 kgf-cm, 74 inch lbs.)
Rear brake:
Drum brake type: 8.3 Nm (85 kgf-cm, 74 inch lbs.)
Disc brake type: 11 Nm (110 kgf-cm, 8 ft. lbs.)
(6) Repeat the above procedures to bleed the air out of the brake line for the other wheel.
f.
Bleed the air out of the pressure reduction line when "Step 3: Decrease" appears on the hand-held tester display.
NOTICE:
^
Bleed the air by following the steps displayed on the hand-held tester.
^
Make sure that the brake fluid in the master cylinder reservoir tank does not become empty.
(1) Connect a vinyl tube to either one of the bleeder plugs.
(2) Loosen the bleeder plug.
(3) Using the hand-held tester, operate the brake actuator assembly, completely depress the brake pedal and keep it.
NOTICE:
^
During this procedure, the pedal seems heavy, but completely depress it so that the brake fluid comes out from the bleeder plug.
^
Be sure to keep depressing the brake pedal. Do not depress and release the pedal repeatedly.
HINT:
^
The operation stops automatically after 4 seconds. When performing this procedure continuously, set an interval of at least 20 seconds.
^
When the operation is complete, the brake pedal goes down slightly. This is a normal phenomenon caused when the solenoid opens.
