Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-297004.png)
15. INSTALL FRONT AXLE HUB LH BEARING
a. Using SST and a press, install a new hub LH bearing to the steering knuckle.
SST 09950-60020 (09951-00720), 09950-70010 (09951-07100)
16. INSTALL DISC BRAKE DUST COVER FRONT LH
a. Install the dust cover front LH with the 3 bolts.
Torque: 8.3 Nm (85 kgf-cm, 73 inch lbs.)
17. INSTALL FRONT AXLE HUB SUB-ASSY LH
a. Using SST and a press, install the hub sub-assy LH.
SST 09608-32010, 09950-60010 (09951-00600), 09950-70010 (09951-07100)
18. INSTALL FRONT AXLE HUB LH HOLE SNAP RING
a. Using snap ring pliers, install a new LH hole snap ring.
19. INSTALL LOWER BALL JOINT ASSY FRONT LH
a. Install the lower ball joint assy front LH, torque the nut.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Install a new cotter pin.
NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.
20. INSTALL FRONT AXLE ASSY LH
a. Push the front axle assy toward the outside of the vehicle, fit the splined part of the drive shaft assy to that of the front axle assy, insert the
drive shaft assy into the front axle assy.
