Corolla L4-1.8L (2ZZ-GE) (2005)
b. Temporarily install the 2 bolts.
c. Place a new lock plate and tighten the nut.
Torque: 5.5 Nm (56 kgf-cm, 49 inch lbs.)
d. Temporarily install the control shaft lever.
e. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
f.
Remove the control shaft lever.
g. Align the groove with neutral basic line.
h. Hold the switch in position and tighten the 2 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 inch lbs.)
i.
Using a screwdriver, stake the nut with the lock plate.
j.
Install the control shaft lever, washer and nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
k. Connect the park/neutral position switch connector.