Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-920010.png)
a. Coat the compression spring and the flow control valve with power steering fluid.
b. Install the compression spring and the flow control valve.
c. Coat a new O-ring with power steering fluid and install it onto the pressure port union.
d. Install the pressure port union.
Torque: 69 Nm (704 kgf-cm, 51 ft. lbs.)
35. INSTALL POWER STEERING SUCTION PORT UNION
a. Coat a new O-ring with power steering fluid, and install it to the power steering suction port union.
b. Install the power steering suction port union with the bolt.
Torque: 12 Nm (122 kgf-cm, 9 ft. lbs.)
36. INSTALL VANE PUMP ASSY
a. Install the vane pump assy with the 2 bolts and nuts.
Torque: 37 Nm (377 kgf-cm, 27 ft. lbs.)
b. Connect the connector to the oil pressure switch.
NOTICE: Be careful to prevent oil from being attached to the connector.
37. INSTALL VANE PUMP BRACKET REAR
a. Install the vane pump bracket rear with the bolt.
Torque: 37 Nm (377 kgf-cm, 27 ft. lbs.)
38. CONNECT PRESSURE FEED TUBE ASSY
a. Using SST, connect the pressure feed tube assy.
SST 09023-12901
Torque: 41 Nm (418 kgf-cm, 30 ft. lbs.)
NOTICE: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
HINT: This torque value is effective when SST is parallel to the torque wrench.
b. Connect the pressure feed tube clamp with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
