Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-945007.png)
11. INSTALL FRONT STABILIZER LINK ASSY LH
a. Install the front stabilizer link assy LH with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
12. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Disposal
DISPOSAL
1. DISPOSE OF SHOCK ABSORBER ASSY FRONT LH
a. Fully extend the shock absorber piston rod.
b. Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.
CAUTION:
^
When drilling, chips may fly out, work carefully.
^
The gas is colorless, odorless and non-poisonous.
