Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-704002.png)
a. Remove the 2 bolts, and separate the rear disc brake caliper assy LH.
3. REMOVE REAR DISC (DISC REAR BRAKE TYPE)
4. REMOVE REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
5. DISCONNECT SKID CONTROL SENSOR WIRE (W/ ABS)
6. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and hub & bearing assy LH.
7. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the hub & bearing assy LH with the 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft. lbs.)
8. CONNECT SKID CONTROL SENSOR WIRE (W/ ABS)
NOTICE: Do not twist the sensor wire when connecting it.
9. INSPECT AXLE HUB BEARING LOOSENESS
10. INSPECT AXLE HUB BEARING RUNOUT
11. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
12. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
