Corolla L4-2.4L (2AZ-FE) (2010)
24. REMOVE KEY INTERLOCK SOLENOID (for Automatic Transaxle) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Overhaul/Disassembly
25. REMOVE SOLENOID WIRE (for Automatic Transaxle) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Overhaul/Disassembly
26. REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Overhaul/Disassembly
27. REMOVE UNLOCK WARNING SWITCH ASSEMBLY
(a) Remove the unlock warning switch assembly by pushing up the center part and releasing the 2 claws.
HINT
Slide the unlock warning switch in the direction shown by the arrow in the illustration to remove it.
Installation
DOOR LOCK: UNLOCK WARNING SWITCH: INSTALLATION
1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY
(a) Make sure that the ignition switch lock cylinder assembly is in the ACC position.
(b) Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.
(c) Make sure that the ignition switch lock cylinder assembly is securely installed.
2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Overhaul/Reassembly
3. INSTALL SOLENOID WIRE (for Automatic Transaxle) See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Overhaul/Reassembly
4. INSTALL KEY INTERLOCK SOLENOID See: Steering and Suspension/Steering/Steering Column/Service and Repair/Overhaul/Reassembly